Room mode calculator
Type your room’s size to see the bass notes it boosts, where they boom, and how even they are.
No reverb time yet? 0.5 s suits a furnished living room; measure yours with the reverb time meter.
The formula is for a rectangular room, so the results are approximate for your room.
Modes per third-octave band (Bonello)
Pressure map at ear height (floor plan)
34.34 Hz (1,0,0), axial: bright = loud bass, dark = little bass. Same at every height. Quiet lines: 1 null along the length.
- 195 modes up to 300 Hz (18 axial, 83 tangential, 94 oblique). The lowest axial modes: 34.34 Hz, 42.93 Hz, 68.68 Hz, 68.68 Hz.
- Room 5.00 m × 4.00 m × 2.50 m, volume 50.0 m³, ratio 1 : 1.60 : 2.00. Speed of sound 343.4 m/s at 20 °C.
- Schroeder frequency 200 Hz (RT60 0.5 s): below it single modes rule the bass; above it they blend into an even sound.
- Bonello check failed: a band with under 5 modes holds two modes at almost the same frequency.
- Clusters (modes closer than the 4.4 Hz modal bandwidth, so they boom together): 68.68 Hz (2 modes), 76.79–81.00 Hz (3 modes), 85.86–87.98 Hz (2 modes), 103.0–115.2 Hz (6 modes), 128.8–153.6 Hz (17 modes).
- Gaps (more than twice the spacing expected at that frequency, likely dips): 54.97–68.68 Hz, 115.2–123.8 Hz, 123.8–128.8 Hz, 153.6–159.5 Hz, 165.6–171.7 Hz.
- The ratio is inside the listening-room range of ITU-R BS.1116.
| Play | Hz | Note | Type | nx,ny,nz |
|---|
Then measure the bass with an RTA at your seat to see which of these modes really boom.
How to use the room mode calculator
- Choose metres or feet and type the length, width and height of the room, wall to wall and floor to ceiling.
- Leave the reverb time at 0.5 s, or type your own from the reverb time meter, and set the ear height of your seat.
- Read the lowest modes, the Schroeder frequency, the Bonello check and the spacing score. The results update as you type.
- Press a mode in the list to see where it booms on the floor plan, and press ▶ to hear it as a quiet tone. Save the list with CSV.
How to read the mode chart
A room mode is a bass note whose wavelength fits the room so the sound bounces back and forth and builds up. Each line on the chart is one mode. Axial modes, the tall amber lines, run between two opposite surfaces: the first one along a 5 m room is at about 34 Hz, where exactly half a wavelength fits. They are the strongest. Tangential modes bounce around four surfaces and are weaker, and oblique modes use all six and are weaker still. The three numbers in the list (nx, ny, nz) say how many half wavelengths fit along the length, width and height.
Clusters and gaps
Every mode rings over a small band, the modal bandwidth, which is about 2.2 divided by the reverb time: 4.4 Hz for an RT60 of 0.5 s. Modes closer than that blend into one bigger boom, so the chart marks them as a cluster with a coral dot. A gap is a stretch more than twice as wide as the average spacing expected at that frequency (modes get closer together as the frequency rises), where nothing rings and bass notes sound thin. Above the Schroeder frequency, 2000 × √(RT60 ÷ volume), the modes overlap so much that they stop acting alone; the grey shading shows that range.
Bonello and the spacing score
The Bonello check counts the modes in each third-octave band from 20 to 200 Hz. It passes when the count never drops from one band to the next, and when no band with fewer than 5 modes holds two modes at almost the same frequency. The spacing score is this tool’s own measure of how even the gaps between modes below 200 Hz are: 100 is perfectly even, and a cube, with its many doubled modes, scores very low.
Use cases
Plan a studio room
If you can choose which room to use, or where to put a new wall, compare the options here before you build. A 4 × 4 × 2.4 m room puts its length and width modes on top of each other at about 43 Hz and fails the Bonello check; moving one wall to make it 5 m long splits them, passes, and lifts the spacing score from 4 to 31. Try the ratio chips to see which proportions spread the modes best for your ceiling height.
Place a subwoofer
A subwoofer in a corner drives every mode, which gives the most bass but also the most boom. Pick the first width mode in the list and look at its map: the dark line across the middle of the room is where it cancels. A sub placed at a quarter of the width, or two subs on opposite walls, excites that mode less. Then measure the bass with an RTA to check the result.
Choose a listening seat
Many people sit with their back against the rear wall, right in the bright zone of every length mode, so the bass booms. Look at the maps of the first two length modes and find a spot that is neither the brightest nor the darkest. A popular rule of thumb puts the seat about 38 % of the room length from the front wall; the maps show whether that works in your room. Set the ear height to your seat and check the height modes too.
Good room ratios
Because modes come from the room’s size, some proportions spread them more evenly than others. Acoustics books often quote three sets found by Sepmeyer, 1 : 1.14 : 1.39, 1 : 1.28 : 1.54 and 1 : 1.60 : 2.33 (height : width : length), and the set 1 : 1.4 : 1.9, which some sources credit to Louden and others to Bolt. The worst shape is a cube, and almost as bad is any room where one side is twice another, because modes then land on the same notes.
For listening rooms, ITU-R BS.1116 gives a range rather than one ratio: 1.1 × w/h ≤ l/h ≤ 4.5 × w/h − 4, with both the length and the width under three times the height. The tool tells you if your room fits it. Treat all of these as guides: furniture, doors, open plans and soft walls change the real result, so measure once the room is in use.
Treating room modes
First move things, because it is free: shift the seat away from the middle and away from the back wall, and try the subwoofer in two or three places while you listen to the worst mode’s tone. Next, absorb. Bass waves are long, so thin foam does nothing to them; thick corner bass traps work best in the corners, where every mode is at its loudest. Last, use EQ to cut the one or two worst peaks at the seat, but never try to boost a dip, since the room cancels the extra power too. The room EQ guide explains how, and the room acoustics tools cover the rest.
We may earn a commission if you buy through these links. It does not change the price.
FAQ
What are room modes?
Bass frequencies that fit the room’s size exactly, so they bounce back and forth and boom at some spots and vanish at others.
Which modes matter most?
Axial modes (between two opposite walls) are the strongest, especially below 150 Hz.
What is the Bonello criterion?
A check that modes are spread evenly across the bass, so no third-octave band has too many.
Can EQ fix room modes?
EQ can cut peaks, but dips cannot be filled. Seat and speaker position plus bass traps help most.